SHOWTEC Explorer 575 Spot Guida Utente Scaricare il pdf (Pagina 11)

Lamp Adjustment

You can adjust the lamp’s position by turning the screws A, B, C.

The lamp position is set in the factory. As the lamps, which can be used, differ from manufacturer to

manufacturer, it can be necessary to readjust the position. The lamp must be readjusted e.g., if the light

does not seem to be evenly distributed within the ray of light.

Ignite the lamp and focus the ray of light on an even surface (wall). As the optimal distance between the

lamp and the lens was already set during the installation with screw "A", only the "Hot Spot" ( the brightest

part of the ray of light) must be centered. Turn in addition screw "B" and “C”. If the Hot Spot appears too

bright, you can weaken its intensity, by moving the lamp closer to the reflector. Turn in addition screw "A",

until the light is evenly distributed. If the light at the outside edge of the ray of light appears brighter as in the

center, the lamp is too close to the reflector. In this case move the lamp away from the reflector, until the

light is evenly distributed and the ray of light appears bright enough.

Fig. 5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Nessun commento

SHOWTEC Explorer 575 Spot Guida Utente Pagina 11